Wsynth-DSSI is a simple wavetable synth. It is not based on any "real life" synth, but was written with the PPG Wave and Prophet VS in mind.

The code is based on Xsynth-DSSI, hence the imaginative name.

A lot of the sound generation code, most of the user interface, and nearly all of the DSSI bits are derived from Sean Bolton's Xsynth-DSSI plugin. This in turn uses bits from Xsynth v1.0.2 by S. J. Brookes.

Limitations:

· The "About" message is unchanged from Xsynth-DSSI

Requirements:

· DSSI version 0.9 or greater, available from the dssi.sourceforge.net address above.
· liblo version 0.12 or later, a library implementing the Open Sound Control protocol.
· pkgconfig with PKG_CONFIG_PATH set appropriately to pick up DSSI and liblo.
· GTK+ version 1.2 or 2.x. (If GTK+ is not found, the plugin will be built without the GUI.)
· the LADSPA v1.x SDK.
· the ALSA headers (DSSI plugins use ALSA structures, but not the actual drivers, so you don't necessarily need the drivers installed.)
· a working DSSI host. Xsynth-DSSI has been tested with the example DSSI host available at the dssi.sourceforge.net address above.
· automake 1.7 and autoconf 2.57 or better if you wish to recreate the build files.

Requirements:

· DSSI version 0.9 or greater, available from the dssi.sourceforge.net address above.
· liblo version 0.12 or later, a library implementing the Open Sound Control protocol.
· pkgconfig with PKG_CONFIG_PATH set appropriately to pick up DSSI and liblo.
· GTK version 1.2 or 2.x. (If GTK is not found, the plugin will be built without the GUI.)
· the LADSPA v1.x SDK.
· the ALSA headers (DSSI plugins use ALSA structures, but not the actual drivers, so you don't necessarily need the drivers installed.)
· a working DSSI host. Xsynth-DSSI has been tested with the example DSSI host available at the dssi.sourceforge.net address above.
· automake 1.7 and autoconf 2.57 or better if you wish to recreate the build files.